Leatherman Heritage Small Brown Leather Multi-Tool Sheath 832593

A Rebar or a Wingman rides in the Small, and this Leatherman Heritage sheath is cut close enough that the tool sits still. Brown vegetable-tanned full-grain cowhide, a reinforced snap, a stitched belt loop.

• Sized for the Rebar & Wingman - The Small holds a Rebar, Knifeless Rebar, Wingman, Sidekick, Rev, Bond or Curl. The leather sits tight against the tool, so it goes in against a little resistance and then stays where it is rather than sliding around on a belt.
• Full-Grain Vegetable-Tanned Cowhide - Leatherman uses the grade that darkens and takes a patina instead of wearing through, and the face runs smooth with a slight sheen under the thumb. The leather has real body from the first day and does not ask for weeks of breaking in.
• Made in the USA - Leatherman builds this one in the United States. Heavy-duty stitching runs the seams, the closure is a reinforced custom snap that shuts with a firm push, and the logo is foil stamped into the face of the leather.
• Stitched Belt Loop - The loop is stitched to the back panel and carries the sheath vertically on the belt. It takes a belt up to about two inches wide, wide enough for a work belt and an ordinary dress belt alike.

The Leatherman Heritage Sheath

The Leatherman Heritage Sheath brings back the leather pouch the company shipped with its earliest multi-tools, when a snap and a stitched loop were all a tool needed to ride a belt. Leatherman still builds it in the United States, and cuts it to four tool sizes rather than one. The pocket closes around the tool it was built for, and the snap has something to pull against.