Olight sRPL-7 Black Magnetic Remote Pressure Switch

The Olight sRPL-7 puts PL-3R Valkyrie control under your support hand. The magnetic connector locks onto the charging port and holds without shifting, then strips off in seconds when you want the light bare again.

• Magnetic Charging-Port Connector - The connector seats on the magnetic charging port of the PL-3R Valkyrie and locks on hard, staying put once it is set. Pull it and the light goes back to bare in seconds, with no tools and no mounting hardware to strip off first.
• Separate High and Low Buttons - Two buttons ride the pad, a large one for High and a small one for Low, so output comes down to which button you hit rather than cycling through modes. Both run momentary, so the light burns while you hold and quits the moment you let go.
• Soft Rubber Pad & Flexible Cable - The pad face is soft rubber and presses firm and quiet under a thumb or a knuckle. The cable stays flexible enough to route around a rail or a receiver without fighting the bend, and two zip ties ship in the box to tie the run down.
• Built Around the PL-3R Valkyrie - Olight builds this switch for the PL-3R alone, and that pairing is what opens the light up to both short and long Picatinny builds. Compatibility is the one thing to settle first, so confirm what you are running before you order.