Rivery Zero V2 Grenade Pattern Gray Aluminum Manual OTF Utility Knife (2.68" Closed)

The Rivery Zero V2 in Grenade Pattern is a pocket-size manual OTF utility knife, gray satin anodized aluminum with raised segments milled across it. Its replaceable razor blade runs out under the thumb and snaps back on a spring.

• Manual Open & Spring-Loaded Close - A push on the lid runs the blade out and locks it there solid. Pull the lid back and the key and spring pull it back crisply. Beware, the fidget factor for these is real and they are quite addicting.
• Grenade Pattern Body in Gray Anodized Aluminum - Raised segments run across the body in relief, adding grip and an index point without going coarse. Gray satin anodizing holds an even, low-shine finish over the aluminum underneath.
• Replaceable SK5 Utility Blade - Standard SK5 utility blades drop straight in, and the V2 blade holder is cut to a wider angle so it takes a broad range including DeWalt, Milwaukee, Stanley, Titan and Workpro. A dull edge gets swapped rather than sharpened.
• Screwless Body with Tool-Free Teardown - The body is held together by its own machined fit, so it separates and reassembles in bare hands. The carriage and bearing surface are built to be serviced the same way, and the springs and internals are catalogued as replacement parts.

The Rivery Zero V2

Engineer Michael Sayers designed the Rivery Zero V2 around a body with no screws in it, three machined pieces held together by geometry alone. Rivery Manufacturing cuts them in a small shop in Sevierville, Tennessee. Closed up, the knife reads as a plain metal block, a non-aggressive shape which will not attract unwanted attention the way a typical folder does. The V2 revision reworked the blade holder and carriage and kept the bearing surfaces simple enough to pull apart and clean by hand.