Leatherman Quick-Release Lanyard Ring Black 934857

Leatherman finishes this Quick-Release Lanyard Ring in black oxide over 420 stainless. It is the American-made part that puts a lanyard, a carabiner, or a split ring on a full-size multi-tool.

• Black Oxide Over 420 Stainless - This is the same 420 stainless ring, finished in black oxide. The coating darkens the steel itself rather than layering over it the way paint does, leaving nothing on the surface to chip off a working part.
• Tool-Free Snap-In Mount - The forked end pushes into the mount on the side of the tool and catches with a firm snap. Nothing needs unscrewing and no driver comes into it. Pull hard and it stays where it is. Press again and it comes away.
• Carabiner-Width Loop - The opening takes a full-size carabiner, not just a doubled length of cord, and that is the difference between a tool tied to a pack and one that clips on and off it at will. Paracord and a split ring both fit.
• Wave Plus, Wave Alpha, Charge & Surge Fitment - The mount this ring was built for lives on the Wave Plus, the Wave Alpha, the Charge family and the Surge. Match the tool in hand to that list. Not every full-size Leatherman shares it.

The bench of parts and carry hardware behind a Leatherman tool runs deep. You will find this ring with the rest of their lanyard rings and pocket clips.